Go-power TS-50 Manual do Utilizador

Transfer Switch GP-TS 50 ________________________________________________ Owner’s Manual 

GP‐TS‐50___________________________________________________________10It is never advisable to start or stop a generator under load. To prolong the

GP‐TS‐50___________________________________________________________11• Damage in handling, including damage encountered during shipment or insta

GP‐TS‐50___________________________________________________________12   © 2011 GO POWER!™ By Carmanah Technologies www.gpelectri

GP‐TS‐50___________________________________________________________2 Table of Contents 1. Introduction The Go Power!™ Transfer Switch 5

GP‐TS‐50___________________________________________________________3READ AND FOLLOW ALL SAFETY INSTRUCTIONS! 2.1 Disconnect Power Make sure the

GP‐TS‐50___________________________________________________________4D. Route internal ground wires around lower area of enclosure and secure to g

GP‐TS‐50___________________________________________________________52. Connect powercord hot 1 and hot 2 to powercord lugs HOT 1 BLK and HOT 2 RED

GP‐TS‐50___________________________________________________________6Diagram 1

GP‐TS‐50___________________________________________________________7 3. Operational Testing READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1. Plug in the

GP‐TS‐50___________________________________________________________8 4.2 General Low Voltage Low voltage can be caused by low voltage conditions s

GP‐TS‐50___________________________________________________________9NOTE: If the hi-pot test is performed from the plug on the powercord, the test